how do i remove factory stereo?? not mach

[ffr66cobra]

2001 GT.. i was looking for the pinholes in the front, but couldnt' find any to release the unit forward. Didn't spend too much time on it after that cause i was busy w/ running wires, and installing the amps... How do i get the factory (non mach) stereo out? is there a screw through a bracket in the back? do i have to take the center console apart? Any help would be appreciated... thanks-- Mike

 

[Kilgore Trout]

Yeah, the pinholes are gone on that year... A Haynes manual will show you the way. Or you could probably google for it

 

[zcs626]

get a panel removal tool or flat head screw driver and pop up the bezel around the shifter (or stick your hands under the shift boot and pull up, just be gentle)

once you get that off, pull forward on the rest of the dash bezel that goes around the A/C and actual radio.

unplug the switches like the fog lights, and rear defroster etc, if you want.

then the radio is held in by two 7 or 8 MM screws i forget which, and there ya go. good luck