how easy is it to degree cams

[orangemachine]

I have been reading a lot about degreeing cams. How easy is it to do this? I have never done it before. Does anyone have good write ups on this? How much would a machine shop charge? I have looked at summit and saw them for like 90-140 bucks.

I wondering if this is my problem because I have ptv contact.

Thanks.

vt stage 2 cams with manley springs in a 00 GT

 

[hotstang_46]

there is a very good article on modular depot that I had found when i was making the decision wether or not to degree....I'd try to find it for you but it seems either the site is down or my computer does not want to go there right now....

I'll try lookin again later for you....and I may be wrong but I want to say it was a sticky in one of the forums...