- Sep 19, 2012
- 19
- 2
- 13
I am going to cut my springs on my 2005 convertible to lower the rear by 1". Folks who have done this say to remove one full coil.
Understanding some don't support cutting springs, I have two questions:
1) Exactly how do I measure one full coil? Just cut the underneath where the end is?
2) How do I make sure the newly cut end sits right, and not at an angle? Some have suggested turning the spring upside down because this put the newly cut end in a more stable position.
Thanks,
BB
Understanding some don't support cutting springs, I have two questions:
1) Exactly how do I measure one full coil? Just cut the underneath where the end is?
2) How do I make sure the newly cut end sits right, and not at an angle? Some have suggested turning the spring upside down because this put the newly cut end in a more stable position.
Thanks,
BB