I damaged my front valence last night by pulling up too close to a curb.
I did a little research, and they are not too expensive to replace, apparently (around $85 at the dealer).
My question is - has anyone else replaced one yet, and if so, what is involved in replacing it?
Underneath, there are regular screws, and also the smaller pin-type with some sort of lock washer above. From looking at it, I can't see how I can get my hands in there to where the two center screws are located, but I may be overcomplicating things.
Any tips? How do those little pin-type screws come out and go back in?
Thanks!
I did a little research, and they are not too expensive to replace, apparently (around $85 at the dealer).
My question is - has anyone else replaced one yet, and if so, what is involved in replacing it?
Underneath, there are regular screws, and also the smaller pin-type with some sort of lock washer above. From looking at it, I can't see how I can get my hands in there to where the two center screws are located, but I may be overcomplicating things.
Any tips? How do those little pin-type screws come out and go back in?
Thanks!