Installed 14point7 Adv 3. Tunerstudio A/F reads 7.8-8.0.

GodStang

Member

Nov 20, 2015

33

4

18

46

Jan 5, 2020

#1

• Jan 5, 2020

• #1

Hello-

I finished installing two 14point7 Adv 3 widebands. Bluetoothed in and set Baud rate to 500K and set ID on passenger side to 1025. I did all the settings per the pdfs on the 14point7 website. When running MS3 and tunerstudio both widebands read 7.8-8.0. Any ideas on what setting I could be missing or what could be wired wrong?

 

a91what

SendMeUrDataLog

10 Year Member

Apr 6, 2011

10,739

6,721

214

37

Hillsborough county

Jan 5, 2020

#2

• Jan 5, 2020

• #2

Link to pdf?
Did you have to calibrate the sensor input in the tools menu?
You may have missed a step.

 

GodStang

Member

Nov 20, 2015

33

4

18

46

Jan 5, 2020

#3

• Jan 5, 2020

• #3

a91what said:

Link to pdf?
Did you have to calibrate the sensor input in the tools menu?
You may have missed a step.

Click to expand...

bottom of page 5 of install says do not calibrate before 500 hours.

Install

https://cdn.shopify.com/s/files/1/0189/1312/files/Spartan_3_ADV_User_Manual_49fad869-6b05-4e69-ac4d-fc5b9862496f.pdf?51

MS3 setup

https://cdn.shopify.com/s/files/1/0189/1312/files/Interfacing_Spartan_3_ADV_to_MegaSquirt_3_via_CAN_Bus_Aug_9_2019.pdf?53

 

GodStang

Member

Nov 20, 2015

33

4

18

46

Jan 5, 2020

#4

• Jan 5, 2020

• #4

ok Alan just emailed me and said on one of the two I have to turn on CAN Resistor “SETCANR1”

will give that a try and update.

 

Reactions: mustang70

GodStang

Member

Nov 20, 2015

33

4

18

46

Jan 8, 2020

#5

• Jan 8, 2020

• #5

So I tried turning on 1 resistor then turned that one off then turned on the other and then turned on both still no luck. Using the Torque Pro App over Bluetooth the numbers look good. I guess my next step is unwiring one of them and getting a single one to work.

 

a91what

SendMeUrDataLog

10 Year Member

Apr 6, 2011

10,739

6,721

214

37

Hillsborough county

Jan 8, 2020

#6

• Jan 8, 2020

• #6

Are you cycling power on the ECU after turning the resistor on?

 

GodStang

Member

Nov 20, 2015

33

4

18

46

Jan 8, 2020

#7

• Jan 8, 2020

• #7

a91what said:

Are you cycling power on the ECU after turning the resistor on?

Click to expand...

Yes any changes I make to the ADV 3 I fully power down then back up reconnect and then I do the GET% command to make sure it still has the change. (ie GETCANID or GETCANR)