Anyone installed a u-joint in an aluminum driveshaft? I've done a million in steel shafts, but I just got an aluminum one and i'm a little gun shy.
The instructions say to use an oxy/act torch to heat up the yokes to allow you to slide the bearing cups in. I tried that, but knowing just how much heat is a tough call - definitely I don't want to melt the yokes.
Normally I'd press the u-joint in with my vise, but again, I'm a little worried about f-ing up the driveshaft.
Google turned up nothing.
Anyone got some experience here?
And yes, I know about the specail u-joints needed.
Thanks,
The instructions say to use an oxy/act torch to heat up the yokes to allow you to slide the bearing cups in. I tried that, but knowing just how much heat is a tough call - definitely I don't want to melt the yokes.
Normally I'd press the u-joint in with my vise, but again, I'm a little worried about f-ing up the driveshaft.
Google turned up nothing.
Anyone got some experience here?
And yes, I know about the specail u-joints needed.
Thanks,