last year when i took the power steering pulley off, i was give the wrong puller when i rented one at the part store. so i ended up bending the pulley. found another one, fast forward a year later. i bought the correct pulley puller set, and go to put the new pulley on. i get about half way on and the thread strips for the piece going into the center of the p/s staft. i also noticed that, even though the pulley wasn't all the way on, it wasn't on straight. by spining the pulley it had a very slight wobble.
could the shaft be bent? and cause to much pressure while trying to put the pulley on strip the threads?
my budget is already at zero, so i'm ready to torch the mother****er.
could the shaft be bent? and cause to much pressure while trying to put the pulley on strip the threads?
my budget is already at zero, so i'm ready to torch the mother****er.