It slipped at the race

68conv4sp · May 10, 2006

Went to an autocross event with my 68 last weekend. Car was performing like a slot car until the right front camber eccentric worked loose. That was it for the day. The alignment shop reset it all for me, but what can I do to prevent a similar occurrance next month? Is tack welding really the best bet, or is there some less invasive method?

Red5oh · May 10, 2006

Dont they have those eccentric eliminators? They are sqaure and have multiple holes in them to set the angles you need... then tighten and forget about it.

bnickel · May 10, 2006

check out the crossmember from www.cobraautomotive.com it has tabs to keep the eccentrics from slipping. or get yourself a copy of the boss 302 handling guide, it has the dimensions and stuff for you to make your own

rbohm · May 11, 2006

promotorsports in sandy utah has the eccentric eliminators. they just bolt in place of the eccentrics. if you want to go the cheap route, you can tack weld the eccentrics in place. that way they can still be broken loose for alignment settings. or you can weld them permentantly and use the older tried and true method of using shims to align the front end.

ttoney · May 11, 2006

I have a set of the Eccentric Eliminators. They are awesome, I would reccomend them.

Also, I am interested in the boss 302 handling guide. Where can it be found? I tried google real quick, no dice. Is it on paper only or?????

Jester67 · May 11, 2006

rbohm said:
promotorsports in sandy utah has the eccentric eliminators. they just bolt in place of the eccentrics. if you want to go the cheap route, you can tack weld the eccentrics in place. that way they can still be broken loose for alignment settings. or you can weld them permentantly and use the older tried and true method of using shims to align the front end.

I have these as well good product http://www.pro-motorsports.com/?page=prod_aeek

Jester67 · May 11, 2006

Referance article http://www.pro-motorsports.com/?page=article_2

bnickel · May 11, 2006

yeah paper only, it's in the books section of most mustang catalogs

68conv4sp · May 11, 2006

Excellent. So it will be a small tack weld to get me thru the next couple of events, followed by the flat sided replacement. Thanks again, guys!

It slipped at the race

68conv4sp

New Member

Red5oh

Member

bnickel

rbohm

ttoney

Member

Jester67

Member

Jester67

Member

bnickel

68conv4sp

New Member

Similar threads

It slipped at the race

New Member

Member

Member

Member

Member

New Member

Similar threads

Privacy & Transparency

Privacy & Transparency