Kinda stupid question but trying to prove a point.

Phatt_daddy said:

Local DA got into a fuss over some emgine mounts and ended up shooting off his mouth adn laying down a bill on this here bet.

He was saying that an '87-'88 v-8 fox uses different mounts that any newer or older v-8 fox. Something about the bolts not lining up w/ the K- member. I told him he was full of ***** and that he could use any from '87 to '93, and should be able to use any from '79 to '86 also. He was also saying that stock mounts from the parts store costed like $250.00. But that is a different story.

Thanks
Nate

Click to expand...

HISSIN50 said:

Later models use a captured mount (which was used on early aero fox verts).

Click to expand...

srothfuss said:

I'll dig a little further into Hissin's post. From 87-92, the engine mounts were different between the Convertible and Hardtop cars. in 93 Ford switched over to the 'captured mounts they used in the convertible cars because they were stronger. The bolt patterns were the same, but the construction was different between the two. Most (if not all) aftermarket replacement parts use the stronger design as their replacements. This is the only difference.

Click to expand...