• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

loading up?

  • Thread starter Thread starter r_stilz
  • Start date Start date Sep 18, 2004
R

r_stilz

New Member
Jul 31, 2004
6
0
0
Georgia
Sep 18, 2004
#1
  • Sep 18, 2004
  • #1
I have been reading and researching these forums for a while now and couldn't find an answer using "search". My car has been loading up on fuel at low RPM's. I have done the basic tune-up (autolite 25's, wires, oil change, filter clean). I have plugged the smog pump but its still on the belt(it was doing it before i did this too). Where should I start? the idle also fluctuates about 200-400 rpm's
I have equal length headers, o/r h pipe, borla cat-back, k&n filter, and 285000 miles
 

5.0Droptop

...all those nights we shared, and you're a dude??
Special Agent Mukity-Muck Whats in Charge Round Here
May 15, 2002
1,785
1,130
233
Indiana
Sep 18, 2004
#2
  • Sep 18, 2004
  • #2
You many want to pull codes.....

if you have stock ignition make sure your plugs are gapped to .052-.054 i usually gap them to .052
 
R

r_stilz

New Member
Jul 31, 2004
6
0
0
Georgia
Oct 6, 2004
#3
  • Oct 6, 2004
  • #3
finally got to pull codes
KOEO:
memory 33
KOER:
94
44
33
21
12
Cylinder balance test passed
thanks
 

HISSIN50

"How long does it take to get help in here?
15 Year Member
Nov 29, 1999
31,179
33
129
Oct 7, 2004
#4
  • Oct 7, 2004
  • #4
what have you done to test the systems which are tossing codes? i would pay close attention to the ECT code (could be out of calibration or just went south, which can cause richness) and the EGR code. Jrichker has posted some nice info on testing these systems - if you search you might find it (or he might post for ya).

good luck.
 
R

r_stilz

New Member
Jul 31, 2004
6
0
0
Georgia
Oct 8, 2004
#5
  • Oct 8, 2004
  • #5
EGR is not hooked up because I disconnected the smog pump. I replaced the ECT, cleared the computer, pulled the same codes. (I expected to pull codes for the EGR and Thermactor system but the ECT has me baffled since I replaced it)
thanks for the replies
 
R

r_stilz

New Member
Jul 31, 2004
6
0
0
Georgia
Oct 10, 2004
#6
  • Oct 10, 2004
  • #6
bump
 
You must log in or register to reply here.

Similar threads

Suspension End link replacement size
  • Teen'93stang5.0
  • May 12, 2026
  • Fox 5.0 Mustang Tech
Replies
6
Views
101
Fox 5.0 Mustang Tech May 20, 2026
Teen'93stang5.0
9
Engine Donor '00 Mountaineer meet '91 Fox
  • 91firecracker
  • May 11, 2026
  • Fox 5.0 Mustang Tech
  • 2 3
Replies
41
Views
499
Fox 5.0 Mustang Tech May 28, 2026
91firecracker
9
7
Engine Random hanging idle
  • 706 Saleen
  • Feb 11, 2026
  • Fox 5.0 Mustang Tech
Replies
9
Views
421
Fox 5.0 Mustang Tech Feb 19, 2026
86HO5.0
8
Engine 1990 LX 5.0L EFI Mustang Fuel Management Problems - HELP!
  • 5.0LXStanger
  • May 25, 2025
  • Fox 5.0 Mustang Tech
  • 2 3
Replies
45
Views
2K
Fox 5.0 Mustang Tech Jul 11, 2025
5.0LXStanger
S
Engine Stalls when downshifting/coasting
  • Scott_S
  • Nov 5, 2025
  • Fox 5.0 Mustang Tech
Replies
11
Views
635
Fox 5.0 Mustang Tech Nov 6, 2025
Mustang5L5
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?