Local club had a dyno day

[DmnStr8]

My notch pulled in a respectible 217hp and 282.95 ft/lbs on its last run. Not bad for a bone stock engine. Also met a guy who knew the previous owner and can tell me some of its history.

Gots to see lots of 02/03 cobras. Everything from a stocker to one pulling just over 550hp. Also got to see a new (picked up on Thursday) Shelby 500 put down just over 450hp.

I've got to go to bed now. If I can I will scan the sheet. Needless to say I was happy. I just went to see the health of the engine and now I feel confident that she is up to being modded.

 

[mob]

wow seeing that most people expect 190rwhp out of stock 5.0's id say that sounds good.

 

[90]

was it livernois motor sports ???

if it was i went there last weekend and no one was there i was so pist!@! i really wanted it done BAD!

 

[DmnStr8]

The shop was "Performance Dyno" in Concord NH.

Yeah I was expecting something around 200hp. The block heads and intake have not been touched to my knowledge. All thats been done is the A/C and smog were deleted and an off road h pipe was installed.

 

[grey5.0beast]

wow thats pretty good numbers for that stock of a motor.

 

[DmnStr8]

The guys at the dyno said that everyone was pulling just a tad high. They think its was because of the nice cool morning.

A stock 03 Cobra put down its rated fwhp to the rear wheel.

 

[25thmustang]

Nice numbers... my dads 91 when stock (pullies and a Prochamber) made 212/276 which was pretty good, but more importantly went 13.3 @ 101 in that trim with 3.55s and some Hoosiers!