low speed fan

[HISSIN50]

Hello,

Time to pick the brains of the wise ones again.

I wanted to confirm the wire one would use to wire in a manual switch for the low speed fan setting. I am not wild about using terminal 17 on the CCRM to switch right to high speed.

in lookin at the diagrams in the FAQ, i was unclear which wire is the correct wire to ground to turn on low speed only (the description verbage was different for low speed than high speed on the big diagram with each CCRM terminal labled).

Thanks in advance for any help!

 

[LoudToy958]

Pin 14 is for low speed. The diagram here is right, just not labeled for low speed.

17 high speed 35 amps
14 low speed 20 amps

Here is a SLIGHTLY more detailed site. You know how to find me if you have any issuse. As always, use your meter. You'll be fine..............LT

http://bellsouthpwp.net/s/l/slantman/COOLING.htm

 

[HISSIN50]

Pin 14 is for low speed. The diagram here is right, just not labeled for low speed.

17 high speed 35 amps
14 low speed 20 amps

Here is a SLIGHTLY more detailed site. You know how to find me if you have any issuse. As always, use your meter. You'll be fine..............LT

http://bellsouthpwp.net/s/l/slantman/COOLING.htm

Shane, thanks for the reply (as usual).

I had looked at those diagrams, and since terminal 14 was labeled as an input and 17 was an output, i wanted to be sure.

and then on the second diagram, they run the wire from terminal 14 though a fuse (and the switch is too ambigious to know if it switches power or ground).

so that was all the reason to ask. Thanks again for the reply and info, Shane.