LT Install: Need Install Tips & Lift

[QU!CK]

A friend and I will be installing my long tubes in a few weekends. Does anyone have any tips or advice?

Also, does anyone semi-close to Charlotte, NC have access to a lift that we could use for a few hours to speed up the job? If so, it would be greatly appreciated!!!

-J

 

[Mod Man]

24 pack of beer! LOL. Naw its not that bad. Just take your time and you will be fine. If you need anything feel free to PM me or call the shop. If you are able to drop the K-member that would make the install a lot faster and a lot less streesfull. We have an engine hoist that hold the motor up while the K-member is down. If we are not using it I might be able to rent it out. Just let me know...and if you need any advise or anything like I said feel free to Pm me or call anytime. Good Luck on the install...

 

[QU!CK]

24 pack of beer! LOL. Naw its not that bad. Just take your time and you will be fine. If you need anything feel free to PM me or call the shop. If you are able to drop the K-member that would make the install a lot faster and a lot less streesfull. We have an engine hoist that hold the motor up while the K-member is down. If we are not using it I might be able to rent it out. Just let me know...and if you need any advise or anything like I said feel free to Pm me or call anytime. Good Luck on the install...

Thanks! My buddy was able to get us a lift for the day through his car club so we will definitely be dropping the K. Any tips or suggestions you'd reccomend that I do before the install...like preperation type stuff?


-J