Master Cylinder Reservoir

jk351w

New Member
Aug 21, 2006
15
0
0
Hey guys...I purchased a roller body and I dropped a 418w stroker motor in and everything is going great with the build (almost ready to drive), however, I noticed that the previous owner of the car (obviously a rocket scientist) had a wire which shorted out laying right on top of the master cylinder reservoir and burnt a hole right through the damn thing. So, I bought a new reservoir and I am trying to install it…but there’s one problem: The rubber washers seem to have been rotted out and I can’t get the reservoir to fit correctly…so I am wondering if anyone has any ideas on where I could get these replaced? (I’d rather not buy a new reservoir just for the washers) If anyone has run into this problem could you let me know what you did to get this issue resolved? Thanks for any replies. :flag:
 
  • Sponsors (?)