Need HELP with Vortech install .. *PIC*

[BrianV]

What goes into the first 90 degree discharge tube on the bottom? I have a 1"(ish) threaded female hole.. I assume some kind of adapter for the bypass valve, but I dont know. I'm working with a used kit and it seems to be missing all sorts of stuff. Any help appreciated!

 

[COBRA90GT]

Have you looked at Vortech's instructions (available on their site)?

Scroll down to the "Installation Manuals - Supercharging Systems" section of the following page & select the corresponding kit (PDF doc):

http://www.vortechsuperchargers.com/support/

 

[RydeOn]

Thats where the bypass valve goes.

 

[BrianV]

Yea.. I have the instructions.. it says a 1" adapter, the bypass valve doesnt screw on to the pipe, apparently you need the adapter and hose. I think I found a solution though, theres a 90degree plastic fitting that is supposed to go on the inlet pipe, but I have a powerpipe so I dont need it. I may be able to trim the fitting to fit a straight hose.

 

[Thunder5.0]

Any plumbing supply store will have the adapters. They go for a buck or two.