Need pics and/or diagrams-5.0 with TF heads and intake

Finally, after more than 7 years since tearing down the donor car, getting ready to put finishing touches on the engine in my 67. I need some help, though, as I have lost my razor-sharp memory to tell me where everything goes.

Engine is a 5.0, stroked to 347, with Trick Flow heads and intake, mated to a T5, all out of a 91 LX. I'm not running the emissions stuff. I have the stock wiring harnesses, with the engine harness mostly installed.

I would appreciate any links or copies of detailed pictures, diagrams, schematics, etc.

Specific questions I have (right now):
1. Large threaded hole on back D/S of upper intake-what goes there? (see Pic #2 below)
2. Vacuum lines: Routing, along with which ones I still need after the emissions delete
3. Two large threaded holes in back of heads, that I can get most of my fingertip into--what goes there? Do they need to be plugged?
4. Accessories/belt routing
5. Coolant hoses/heater hoses routing

Current state:
View attachment 131797

Pic #2
View attachment 131800

THANKS!

madspeed said:

#2 goes to brake booster on mine. If youre running vac tree you could go to a port on the tree

Click to expand...

So if I'm not running a brake booster at all, then I should just plug it?

I don't think I'm going to need anywhere near all the vacuum ports I already have on the bottom of the intake, with all the emissions gone.

I like the look without the TF logo, but it sure didn't polish up as good as I would have liked it to.