Need Rear End Advice!!!

use a impact(electric or air) or a big breaker bar

lift the car, and set it on jack stands on the frame rails. let the axle hang down all the way. the axle rests on top of the springs, so to releave all tension from it you need to let the axle and rear suspension hang down all the way.

Need Rear End Advice

Remove the bolts holding the leafsprings, and take the entire rearend and springs out. Sound like alot of work, but no more than what your having now.

uggg. the eye bolts are going to be a massive bitch.

If you have a floor jack, use half of the lever as a cheater bar. Mine has a nice rubber grip and slides right over the end of a 1/2" ratchet. Some times you get lucky and the u-bolt breaks.

6Stang7 said:

uggg. the eye bolts are going to be a massive bitch.

Click to expand...

they suck

Sawzall and cut the ubolts? Be sure to have the rearend supported as well or BANG BOOM SOMETHING BROKE!!

Since you're junking the 7-inch rear (best thing to do) it is easiest to remove the rear u-joint then both ends of both leafs while leaving the axle still attached (as has been suggested).

BUT...you knew that was coming right...leafs that have been on there for almost 39 years may not want to come off and you could probably use the wiggle-space that disconnecting the axle will provide.

Put the entire car on jack stands, 4 are better than two to stabilize the thing. Spray some penetrating oil on all 8 u-bolts, both eyes, and all four shackles. Do this every evening for a week and next weekend begin by undoing the u-bolts. Once the four u-bolts are loose then the u-joint and you can get at the prings better. Be careful working under the car while it is on stands, and be careful when the axles comes loose, the 7-inch rear may be wimpy but it's still a heavy beyatch to be dropping on yourself.

Oh yeah, glad you got your parts, and glad to be able to make you a good deal on some 9-inch parts while also helping to clean out my garage