Need to find the inner tie rod roll pin/rivets

[66Runt]

Bought a nice set of Moog inner tie rod ends ('89 Mustang), only problem is they are missing the little rivets that hold the nut from turning on the rack.

Does anybody here know where I can buy these?
Anybody try tapping the holes and using set screws?

TIA,

Scott

 

[bubba-dough]

My Dana ones came with set screws.

 

[8950HO]

Just go to a fastener supply place and buy two 1/8" roll pins and tap them in.Forget the rivets.

 

[rd]

I think original was rolled pins. I pull them out with a screw threaded in them and use them over again.

A set screw would work fine also.

 

[66Runt]

Thanks for the help!

Much appreciated. Orignially they come with a push-pin rivet, which is kind of nice. Problem is I can't find them
I'll probably tap them for setscrews.

Thanks again!

Scott