possible power level,no dyno

mynephratieri

New Member
Dec 12, 2006
19
0
0
ok any ideas on hp numbers?holley systemax intake,1.7 roller rockers,underdrives,24lb injectors with C$L 76mm maf,adj fuel reg at 39 to 40 psi,255 fuel pump,cold air fenderwell,jba headers,h-pipe no cats,to mac pro dumps(all 2.5 in exhaust)no egr(spacer delete)timing around 12 to13,smog delete,bottom is stock.there are no shops around here to test,no track either.as an automatic tranny,0-90 mph is 15.5 0-60 is 8.12 to 8.80.what do you think?
 
that sucks,isnt stock around 220 from the factory?i was wondering on the heads if that slows the air flow.need to get that next i guess.cam is stock.good heads,afr?edelbrock?should have got the holley heads at the same time,but limited funds.bummer!thanx guys
 
that sucks,isnt stock around 220 from the factory?i was wondering on the heads if that slows the air flow.need to get that next i guess.cam is stock.good heads,afr?edelbrock?should have got the holley heads at the same time,but limited funds.bummer!thanx guys

Stock they are rated at 225hp, but that's at the crank, not the wheels. A bone stock 5.0 probably puts down about 190 to the wheels. My friends dynoed at 200hp at the wheels stock (maybe exhaust), but everyone said that was high for a stock 5.0.
 
stock mustangs put down 170-190 depending on the cars condition and the dyno etc etc.

you have alot of good parts just are missing the heads and a cam. the intake flows good but flows TOO MUCH for the stock heads.

bigger MAF isnt helping at all, its still sucking through the same stock TB which is smaller, no need for 24 lbers now, the Fuel pump is good for future mods and has no effect on power now. its just extra fuel whenever u need it.

just get a nice set of heads, cam and a bigger TB and the car should pick up alot of power.
 
hmm i guess i didnt see u had a TB

porting stock heads would help.

u could get some gt-40 heads, get them ported for some extra power. and grab an E-cam or stage 1 TFS cam that would help out alot.