project T top coupe update for those who care

[SVT32VDOHC]

I think it's spot on. That's where I cut both of mine. I was stil able to use the fox door handles too. They cleared the dash but I did have to trim about 1/8" or more of dorr handle. No biggie. You cut a little too much off the passenger side so you will have a gap between the dash and the lip of the windshield edge. No worries, I did the same thing to my current project. I was paying closer attention to other alighment issues and didn't realize what I was doing.

It looks great...keep up the great work.

 

[Trbofox]

Nice project, looking good.

 

[S&B]

okay finally got the dash bolted up had to cut the main tube to get it in, maybe the 1981 body is not the same i dont know but it would not mate up tight without it.

used a piece of cardboard as the windshield to make the clearances.

now i have to figure this welder out b/c i have alot of welding to do and im very not good at it

Ohh also got the new carpet, for a 2002 interior looks great and has backing

 

[NIKwoaC]

You sure that Johnson will have enough power to help you safely merge on the freeway?

 

[1991notchbackLX]

Looks really good S&B! How hard would it have been for Ford to just hit those dash mounting brackets with a coat of paint at the factory?? They're always covered in rust and it annoys the hell out of me any time I see them. Sorry, back on topic. Nicedashboardzomgwtfbbqkhi2u2.

 

[Shaolin Crane]

Looks really good S&B! How hard would it have been for Ford to just hit those dash mounting brackets with a coat of paint at the factory?? They're always covered in rust and it annoys the hell out of me any time I see them. Sorry, back on topic. Nicedashboardzomgwtfbbqkhi2u2.

i painted mine when i put them back in

 

[S&B]

you would !!!

 

[Shaolin Crane]

you would !!!

yeah i sand blasted them too, they looked like **** and there was no way i could put them back in like that

 

[TOOLOW91]

sometimes i feel like my entire life is a project

so at 19 is it bad that i feel the same way hahaha ... the rendering is insane dude

 

[Chrome_Rust]

I would fiberglass or seal that tube somehow. That is also the ducting for the drivers side A/C vent. If you are going to make it work again...

when I put mine in, i had no issue with that tube at all... wonder what the difference could be...

 

[S&B]

i could not get the driver side to lie flush by the door, the metal pipe is hiting the upper firewall so i cut a big slice out, ill just flip it over and weld it all back up

 

[91svtcoupe]

Sweet Ride.....Can't wait to see it completed...

By the way your PM box is full......I would love to know how to get a rendering like the photoshop you have....

 

[S&B]

his email is in the rendering on on the right hand side under the car