i just got done converting my 86 5.0 to mass air after three years of dic***g around just now trying to start it and i have a hot fusible link...checked every single wire and if it was even bent and MAY have caused a problem i cut soldered and heat shrunk every connection...anyway with the key on if i move the distributor around a little the fule pump primes and it clicks and junk...i have upgraded to the cobra gt40 intakes and the thermostat housing is bigger than stock so the module rubs and on it..initially a lot until i got frustrated and yanked it forward...quite stupid so my question is is there possibly something cracked in the module causing this problem? or would it have to be the wiring because no matter how much i play with the wiring attached to the module it doesnt do anything it's only when i physically move the distributor....anybody know how to quickly test the module to make sure it is in face the problem? also if i need a new one would it be beneficial to upgrade the module to an accell or no difference since it's a stock distributor? thanks for your brilliant genius
"save a tree....eat a beaver"
"save a tree....eat a beaver"