Rear bumper letter install

[RedPony]

i need the link for the how to article, to install my vinyl lettersanyone have it? thanks in advance.

 

[98stang4.6]

this is very easy to do ..... use rubbing alcohol and clean the desired area. make sure its clean and dry then apply the vinyl letters

 

[Benny]

Clean the surface as suggested above.
Then mix a little soap with water in a spray bottle and wet the area so you can move the letters in postion. Once you have them located lightly squeeze the water out. I used my drivers license!

 

[UA2k1GT]

Clean the surface as suggested above.
Then mix a little soap with water in a spray bottle and wet the area so you can move the letters in postion. Once you have them located lightly squeeze the water out. I used my drivers license!

 

[01GT eibach]

What I did was have a little cup of soapy water. Remove the letter's backing and fully dunk the letter in the water. Then it will slide around to exactly where you want it. Once in place, squeeze any air out and let dry overnight. This is truly the world's easiest mod ... even easier than replacing the air filter with a K&N. Five minutes tops. Just make sure you have a nice clean bumper to put it on.