Removing stock side skirts on a 02 GT? Please Help!

derek02gt

New Member
Dec 25, 2003
255
0
0
rear bumper and side skirts left on my saleen install..front bumper,wing,side scoops completed...I am now removing the side skirts and had a few questions..theirs one screw on the front and one on the back..one those are taken off, is their any drilling or such to do to take these suckers off?or do I just pull real real hard? also i guess I have no choice but to remove the rear tire to access the back screws? thanks in advance.
 
on mine, i had many plastic push plug things all along the bottom edge(for lack of better words). I think front piece had a plastic tonge that slid in to bigger piece. But its been really long time. I'll dig up some old pics to see if i can show u what i'm talking about
 
When you open your car door look down and you will see a thin black strip that says "Mustang" that runs the length of the door.

That strip has push pins beneath it which which clip the skirt onto the car, pry that black strip off.

When you install your saleen sideskirts that black strip must be reused to clip the skirt onto the car, but the black strip is too long. You have to cut it to make it short enough to work with the saleen skirts.

There is no 3M adhesive involved in the removal or installation of this project.

Oh and im pretty sure like mity said there are clips under the car too but i cant remember.

The saleen kit doenst re use the clips under the car... it just Ghetto hangs there.