Question, I am trying to set the float level on my Autolite 4100. This is my first rebuild. Do I measure the float level by holding the tab down on the seat with my finger and measure the height of the float ? To change that I assume I just bend the tab to the appropriate height. Just want to do it right, so any tricks or tips are appreciated.
setting the float level ???
- Thread starter thenewguy65
- Start date
Yes, you need to hold down the tab, and then measure the height of the float in relationship with the "top" of the carb. You need that small L ruler the rebuild kit came with.
Check step 22:
http://www.advanceautoparts.com/english/youcan/html/pht/pht20020301cr.html#
Check step 22:
http://www.advanceautoparts.com/english/youcan/html/pht/pht20020301cr.html#
Similar threads
