shortblock question

blown90notch

New Member
Oct 16, 2008
14
0
0
a friend of mine has a 5.0 shortblock out of a 94 cobra.first question is:

1: is there anything special about the cobra shortblock compared to a gt shortblock?

2: what would it take to use that shortblock in my 90 coupe,,is there anything i have to change on the block to make it work?

the block in my coupe needs rebuilt,and my friend has this good shortblock.i am trying to compare the cost of rebuilding my block to buying this good shortblock and what it takes to make it work in a fox.

any thoughts on this would be highly appreciated.
mark
 
so i should be able to just bolt my parts from 90 on the short block and be good?sweet!of course i have twisted wedge heads, and anderson ford motorsport cam and some other goodies for it.oh and a paxton supercharger.:D
 
i have to get new push rods,and the heads are in the machine shop getting totally rebuilt.damn valve guide problems.i bought the car with the problems and am just getting around to fixing it.as far as lifters go,they are still in the block with the cam so i should be good with lining them up.i didnt think it mattered as much with the roller cam motors as far as putting the lifters back on the same lobe.maybe i am wrong.
 
With an HR camshaft, lifter/lobe wear is nothing compared to the old flat tappets. Many have mixed and matched lifters to different lobes on a HR camshaft with no problems.

The camshaft is different between the Cobra and LX/GT blocks.
 
With an HR camshaft, lifter/lobe wear is nothing compared to the old flat tappets. Many have mixed and matched lifters to different lobes on a HR camshaft with no problems.

The camshaft is different between the Cobra and LX/GT blocks.

+1....mixing and matching isn't an issue with HR setups.

One more difference which may or may not be relevant to you, but your stock 90 shortblock comes with forged pistons while your friends has hypereutectic. Forged is only really a benefit if you were to run nitrous or a forced induction setup...as they hold up to detonation far better than their hyper counterparts. That's not to say they won’t hold up under boost....you just need to make sure your tune is spot on.
 
that is a good point.my car has a paxton on it,its only 6psi so it may not make to much difference.

my thoughts are to get this shortblock so i can get the car running,then build the 90 shortblock and maybe even put a stroker kit in it for later.who knows. thanks for the advice!