Solid Lifter for Degreeing the 4v Cams??

[dlascoskie]

I've heard of people welding a fully-pumped up adjustable lifter, and using that to degree the cams. Any drawbacks or tips/tricks I should know about this method. Also, anybody got any links or ideas for a different method? And finally, if you've purchased SHM reground cams, do they send the solid lifter with the kit? Thanks in advance.

 

[Greenbird]

If you've purchase SHM regrinds, throw them in the trash.

You need more than just a solid lifter, it needs to be adjustable, so you can set it to zero lash. a fully pumped lifter may be too tall and give you bad readings. TuffEnuff sells them on forums for like, $10. Get two.

 

[dlascoskie]

Throw the SHM regrinds in the trash? And why would I want to do that???

(Insert SHM bashing threads below)

 

[dlascoskie]

Anybody got any links or info on a good valve lifter to use? I can't find squat and haven't been able to find anything about Tuff Enuff either.

 

[nyuk98gt]

dlascoskie:

Try "NeverEnuff" (Matt) on MD. He has the adjustable lifter hook-up!

Chris

 

[dlascoskie]

thank you sir

 

[dlascoskie]

Any chance of somebody who is registered at Modular Depot pming Matt with my info, as I've registered on that site 3 times in the last 2 weeks and haven't been approved to post or send messages yet. It's getting kinda frustrating. If someone could please ask him to email me at [email protected] , I'd greatly appreciate it.

 

[RandyStinchcomb]

Any chance of somebody who is registered at Modular Depot pming Matt with my info, as I've registered on that site 3 times in the last 2 weeks and haven't been approved to post or send messages yet. It's getting kinda frustrating. If someone could please ask him to email me at [email protected] , I'd greatly appreciate it.

nah, MD is about done as far as a quality modular forum goes

I know Matt has been hanging out on MR=Modular Revolution.com try him there

 

[dlascoskie]

K, I'll try it. Thanks.