Steeda 19 or E-303 cam?

from what i understand your not supposed to change the cam in the 94 and 95 cars unless you have changed the computer. some people have gotten away with it though. someone else will probably know more about it.

Ditto on last post,,,some people get away w/either one of those but some dont. If you have a tuner/dyno facility close maybe they can help ya w/custom tune or chip. Keep us advised.

i have a 95 with a ffrp f cam , stock computer with hypertech chip and i have no problems at all with the setup , its just a little rough idle but thats normal with a big cam

I owned an AODE 95GT with a Steeda #19. To be honest I'd do a stock cam with 1.7s before I did that again. The #19 was all right after changing to a 5 speed, but just didn't have any bottom end for the AODE.

As for the computer the #19 ran fine since it has such a wide LCA (115). It is made for the 94/95 cars after all so thats not an issue. However the e303 has a much narrower LCA (110) that its a crap shoot if it will idle ok or not.

As for the TB the 75 is probably a little big. If you do go with a cam its probably ok. If you do go the stock cam 1.7 route then a 65 is a better choice.

Another "problem" with putting a cam in is the 3.73 gears are really not enough for an AODE car. I know thats what I had as well.