Stock Clearance Measurements Needed

[cleveland]

Can someone actually measure the clearance of their stock height 05 GT at the center inside of the front and rear wheels so I can compare them with my dropped measurements? I want to know if Eibach's listed Sportline drop is correct or not.

-Dan

 

[BLK05GT]

Front is 28 1/4" both sides
Rear is 29" both sides

(That's why my Eibach springs are on order, it looks goofy to me!)

 

[cleveland]

I actually meant ground clearance. To make it easier I only need height from flat ground to the rocker ground effects in front of the rear wheel and behind the front.

-Dan

 

[BLK05GT]

It's kind of tough to tell, but from my shop floor to the lowest point is:

front 5-3/4"
rear 6-1/2"

The plastic moves a bit, so this isn't going to be as accurate as my fender lip measurements...

 

[cleveland]

I took a look @ a stock GT, still sitting on a lot actually, and the measurements came out to about 6 1/2" @ the front of the rocker effects and 7 1/4" in the rear. These were recoreded at the lowest points at the underside of the rocker panel.

My Sportline dropped clearances are 3 7/8" in the front and 4 1/2".

This equals out to a 2 5/8" up front and 2 3/4" out back. Of course these are estimates of what the real drop is but its safe to say that its not much less. See sig.

-Dan