Strut Tower Brace for Trick Flow Mods

[Ed Calvert]

Hi All,
I've installed the entire Trick Flow HCI kit on my 95 and am looking for a replacement strut tower brace as the original factory brace no longer clears the new upper manifold. Any ideas?
By the way, this HCI kit along with 3.55 gears and high flow cats made a big difference. Going to dyno it this weekend hopefully.
Thanks for any help or comments

 

[urban96]

i think the steeda and bbk ones will clear

 

[cavscout371]

steeda make them

OT but did you do it yourself if so I have the same kit other than the oil fill kit and intake spacer what problem did you run into?

 

[cavscout371]

let us know how your dyno goes I know would like to get kind of an est of what I'm going to laydown with my setup I'm going to put on I'm hoping for 350rwhp n/a with the 1.7's and longtubes and quite a bit more when I hit the juice

 

[Ed Calvert]

Ok. I had a mechanic at an SVT dealer do the install. I just dyno'd this afternoon and I'll start a new thread on this forum to itemize the results test results.So look for a thread titled Trick Flow HCI Dyno Results.

 

[Ed Calvert]

10-4 thanks
I did call Trick Flow and ask them about the brace and they said that the Ford Racing M-20201-A51 strut tower brace used for the GT-40 induction will work as well.