I've been building the stang for two years, and I have forgotten how the throttle body cable goes on the bracket. However, either way I go whether the little bracket for the screw is on the front or back side of the bracket, the cable is still too short and holding the throttle about 1/3 open. Attaching pics. Anyone ran into this before? This is the same cable that came off the car when I tore it apart, and the only change inside the engine bay has been a qa1 kmember. Anyone have any suggestions on a fix? I work for a machine shop so I can fab a special washer to push the cable foward on the bracket, or I can bend the bracket, which would be a lot. The picture shows the cable without any pressure on the pedal, maybe even detached from the pedal. The problem lies in the distance from the bracket to the snap point to the tb of the cable. Any suggestions? Thanks.