time to start the winter mods

99e92a73.webp

6f1a3181.webp

Came out darker then expected...
 
39c6cfc0.webp

e981f38f.webp

Ended up getting a new ball joint... Hope to finish running wires this weekend if we don't have a mad dash to get the motor back in the race car
 
got the brakes on last night and almost finish running the wires in the fenders. plan to have the starter relay bolted up tonight battery wire cut and re done since its about 2 feet to long now. and start getting the rest of the wires hooked up. going to need to make a new starter wire since its going to be to short now. hope i can get away with 4Ga on it. that way i dont need another roll of 2Ga at 100 bucks or whatever it was
 
My luck relay would go bad first time I drove it and two more time just cause I made it harder to get to when I tucked my harness I left mine in stock place but its looking great engine compartment looks so much cleaner with a good tuck job
 
Man your welcome to stop by and check out how I did my wire tuck . Tucked everything but coil and relay cause I've just got so much going on right there it still looks super clean and I think it looks;) kinda cool to see a msd coil;)
 
Since I'm tired of bending over the car when it's on the ground
90d74078.webp

4.5" high... 4' long so I can get under car no matter how low I put it
 
must be my lucky day... found the ROL head gaskets that have a better fire ring set up over the felpros for 12 bucks a gasket local :)
 
faacca6f.webp

Car is back on the ground... Started fixing the coil harness. This is the type of :poo: that pisses me off. This was under about a roll of electrical tape and some nasty foamy crap