Timing change

The guys with higher static advance are probably running alum heads.

There is no magic number - no one's motor, combo, etc are the same. Just gotta keep bumping till ya hear ping and then back it down a couple.

Good luck.
 
Yeah I know that. I was thinking of running like 16 degrees.So far thats the best I've heard and read. Just want some more opinions. I have a 91' Mustang GT manual trans. I have a good amount of mods.....Flowmaster cat-back exhaust with high flow cat,4.10 gears,bbk cold-cold air intake(fenderwall mount),and short throw shifter. Next upgrades..Edelbrock upper and lower intake,corba rockers, and some type of long tube headers.


and thanks for all the help.
 
St4ng07 said:
Yeah I know that. I was thinking of running like 16 degrees.So far thats the best I've heard and read. Just want some more opinions. I have a 91' Mustang GT manual trans. I have a good amount of mods.....Flowmaster cat-back exhaust with high flow cat,4.10 gears,bbk cold-cold air intake(fenderwall mount),and short throw shifter. Next upgrades..Edelbrock upper and lower intake,corba rockers, and some type of long tube headers.


and thanks for all the help.
If you read my above-reply, that should be a safe way for you to maxmize your ignition advance.

FWIW, there is a point where you go too far - power will start to decline, but this happens before detonation might occur. Another reason to not run on the ragged edge of detonation.

Good luck.