TKO install questions

[slappypappy]

TKO going in a 91 mustang...do I have to do anything special at the crossmember? I will be using a Lakewood bell...do I need a new motorplate or will the one off of the stock T-5 bell work? Thanks in advance [email protected]

 

[DemonGT]

the lakewood should come with its own motor plate...crossmember spot welds have to be ground down to let it slide back

 

[v8only]

the block plate will work fine. Don't forget to get a new driveshaft yoke.

 

[TIMMY2734]

the block plate will work fine. Don't forget to get a new driveshaft yoke.

no, if hes using the lakewood scattershield, he needs to use the lakewood plate.

 

[v8only]

crap, my bad. thanks for pointing that out. I usually don't give out bad information like that.

 

[DemonGT]

just as i said haha

if you have a brand new TKO it should of came with the correct driveshaft yoke...but if you got it used and dont have it...either find a tremec dealer to get you one...or if you dont already have a alum. driveshaft get the shaft for the mod motors