Update on Kenne Bell 6psi poor dyno results

[mrpositraction]

Hey everybody, beggining of this week I posted that the results of my 6 psi Kenne Bell. Well I just got done talking with Ken at Kenne Bell and he is sending me a 7 psi pulley, wrench and a switch chip with two different calibrations to get me were I am supposed to be. He is shipping this stuff tonight so I expect it some time next week. I will then take it back to the dyno and get some more results. I hope all this stuff works.

 

[w00t]

Sweet. Let us know how it runs.

 

[Laser-01-gt]

Hey everybody, beggining of this week I posted that the results of my 6 psi Kenne Bell. Well I just got done talking with Ken at Kenne Bell and he is sending me a 7 psi pulley, wrench and a switch chip with two different calibrations to get me were I am supposed to be. He is shipping this stuff tonight so I expect it some time next week. I will then take it back to the dyno and get some more results. I hope all this stuff works.

I am sure you guys will figure it out. I should get my 6# kit on tuesday. I have dusted off the old g-tech pro, and did a bunch of runs using the HP mode. i made a total of 6 runs on the same road, going both directions. My avereage was about 220hp. i know it does not replace a dyno, but the G-tech is consitant, if not 100% accurate. the numbers are usually a little lower then a dyno. if i cant get over 300hp when the kit is installed, i will get it dynoed, and give Ken the results.