Updating KAMRF

[Guero]

How do you get them to show on the datalogs??? I've tried disconnecting the battery over night, pressing the brakes for 30 seconds, and with the battery disconnected I touched the wires. But they just show up on my logs as 1. Aren't they suppose to move like the Lambse???

 

[tjh566]

they are suppose to be 1 as far as I understood, 1 means its dead on, more or less than one means somethings a little off in the AFR/tuning.

 

[WhiteDevil]

The problem is you keep resetting it. They will stay at one for a couple drive cycles until the have "learned" enough information for the computer to start making long term changes which is what KAMRF is.

 

[Guero]

Oh ok! Ill keep running the Calcon on, and see if they change

 

[m0l0]

Karmfs will start to move arround once some parameters meet the criteria of the EEC for examle on the scalars there are two called "ACT Maximum & Minimum for adaptive control" and i think another ones , so once this parameters are meet the adaptive control (Karmfs) will start to move

Definitely there more on this matter as the function table that controls the adaptive function.

I hope some others with more experience will chime in and expand this matter

Also in case you missed! don't forget to activate on the payloads the karmfs logging!