• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

Whats the Smog Canister For, and will i pass Emissions w/out it?

  • Thread starter Thread starter Kdubslugga
  • Start date Start date May 1, 2004

Kdubslugga

Active Member
Jun 7, 2003
1,515
3
38
Akron, OH
May 1, 2004
#1
  • May 1, 2004
  • #1
I dont have a smog pump, but i passed Emissions anyways. I was wondering what exactly does the smog or vapor canister do? I unplugged the electrical crap connected to it, and i didnt get a check engine light, so i wanna ditch that thing, would it have any affect on emissions?
 
8

89rdgt

New Member
Apr 24, 2004
103
0
0
Washington
May 1, 2004
#2
  • May 1, 2004
  • #2
The carbon canister collects extra fuel vapors inside it. Once you turn your car off unused vapors are stored in the carbon casnister. So when you start your car again those vapors while eventually be used. Weather or not youll pass i am not sure. I dont see why not you would just be venting your fuel vapors to the atmosphere instead of burning them in the combustion cycle.
 

BlackFox5.0

Founding Member
Aug 7, 2000
3,514
1
0
Massachusetts
May 1, 2004
#3
  • May 1, 2004
  • #3
It won't affect your emmissions. the purpose of it is so that it reduces air pollution (kinda minimal, but it adds up considering how many cars are on earth) and so that you tank can vent, but not vent into the atmosphere, where you fuel can evaporate out of the tank, which is bad. just don't plug up the line because then you will get pressure in the tank, which also is bad. You'll know when you have it when you open your gas cap and air comes out of it, and hisses.
 

Kdubslugga

Active Member
Jun 7, 2003
1,515
3
38
Akron, OH
May 1, 2004
#4
  • May 1, 2004
  • #4
So i get rid of the canister itself, and the tubing upfront. When i pull the plug out of the gas tank area, should i just leave it be, dont plug it up or anything?
 

BlackFox5.0

Founding Member
Aug 7, 2000
3,514
1
0
Massachusetts
May 2, 2004
#5
  • May 2, 2004
  • #5
Leave the tubing up front, but remove the soleniod, and just leave the line that comes from the tank diconnected from the intake. It usually crosses over the front of the engine behind the alternator, and distributor. i would point it down at the ground so the vapors go under the car and not into the engine bay, you could end up having a very slight gasoline smell, but it should be very minimal, and non-existent, but that doesn't mean it won't smell.
 
8

85GTlover

New Member
Mar 20, 2004
704
0
0
May 2, 2004
#6
  • May 2, 2004
  • #6
" non-existent doesn't mean it won't smell". [/QUOTE] A fart?
That is how bad reporters make people they want to criticize look bad, delete certain parts to make them mean other things or to be taken out of context. I just wanted to thank you about the tube that runs from the intake to the canistor things you explained on here. Now I can do it with confidence, before I was second guessing what to do.
 

BlackFox5.0

Founding Member
Aug 7, 2000
3,514
1
0
Massachusetts
May 2, 2004
#7
  • May 2, 2004
  • #7
lol, n/p. I haven't done this before, but my brother has, and I just might too. I don't know if the solenoid works or not, but im not getting any pressure in the tank.
 
M

Matts89LX5.0

Founding Member
Nov 1, 2002
1,314
0
36
Long Island, NY
May 2, 2004
#8
  • May 2, 2004
  • #8
smog/air pump is only required for emissions in California I believe.
 
8

85GTlover

New Member
Mar 20, 2004
704
0
0
May 2, 2004
#9
  • May 2, 2004
  • #9
My car has it in Ontario Canada area since new so there must be other places that need or needed it. It has to be many more than Cali you would think. No?
 
S

shorty1993

New Member
Apr 16, 2004
212
1
0
Gadsden, AL
May 2, 2004
#10
  • May 2, 2004
  • #10
i took mine off a couple of weeks ago. where the line runs into the intake, plug it (buy these in assortment packs at auto store). i went to where the gas line runs back through the fender and cut it off, leaving just enough to fish it through a close by whole. i have not noticed smelling any fuel this way.
 
You must log in or register to reply here.

Similar threads

J
Emission problems
  • jls.zmmr
  • Feb 5, 2026
  • 1994 - 1995 Specific Tech
Replies
2
Views
251
1994 - 1995 Specific Tech Feb 7, 2026
AeroCoupe
Engine 1990 LX 5.0L EFI Mustang Fuel Management Problems - HELP!
  • 5.0LXStanger
  • May 25, 2025
  • Fox 5.0 Mustang Tech
  • 2 3
Replies
45
Views
2K
Fox 5.0 Mustang Tech Jul 11, 2025
5.0LXStanger
Progress Thread Giving an abandoned 88 GT project a new chance at life
  • jaketractor
  • Jan 9, 2025
  • Fox 5.0 Mustang Tech
  • 2
Replies
27
Views
2K
Fox 5.0 Mustang Tech Jul 20, 2025
Noobz347
A
Resolved 03 GT Parasitic Draw Fuse 26 (PCM)
  • Antrix
  • Mar 22, 2025
  • SN95 4.6L Mustang Tech
Replies
2
Views
752
SN95 4.6L Mustang Tech Mar 24, 2025
89ripper
F
Electrical From scratch: alternator wiring
  • fox racer v2
  • Jun 23, 2025
  • Fox 5.0 Mustang Tech
Replies
0
Views
588
Fox 5.0 Mustang Tech Jun 23, 2025
fox racer v2
F
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?