Which bell housing?

[Bignose]

I just ordered my richmond tranny and need a bellhousing. I have a 157 tooth fly wheel and it is going on a 351. Any ideas on sourcing the correct bell?

Thanks in advance

Eric

:SNSign:

 

[GrandeStang73]

What type of Trans is it TKO, Tremec, T5, or T56?? If so one of those out of a fox body would work just fine with that, they came cable or hydralic actuated.

 

[rbohm]

lakewood has the bellhousing you need. ust let them know what tranny, flywheel tooth count, and type of clutch linkage you are going to use.

 

[D.Hearne]

I just ordered my richmond tranny and need a bellhousing. I have a 157 tooth fly wheel and it is going on a 351. Any ideas on sourcing the correct bell?

Thanks in advance

Eric

:SNSign:

You need to find out what the input shaft length is and what bolt pattern the Richmond has first. Also with a 157 tooth flywheel, and a 351, you're going to need a serious clutch and pressure plate to handle the torque with a 10 to 10.5 inch clutch. Something at least along the lines of a CenterForce Dual friction clutch P/P setup.

 

[Bignose]

Already have the centerforce dual friction clutch. I was hoping ot source an used oem bell housing. I ordered richmond trans 7041710A. Should be same exact as top loader.

thanks Eric

 

[Bignose]

Hey guys i found a Bell housing Part number C5AA-6394-B. Will this work with my 10.5 fox body flywheel?

Thanks again

Eric

 

[D.Hearne]

If that's a six bolt bell, yea. I'm using a late 60's bell with the same flywheel in my Ranger for it's Toploader 4 speed. Make sure you either install Heli-coils in the 4 bolt holes for the transmission, or make sure the threads are OK, then use bolts that will extend all the way into the holes.

 

[Bignose]

You rock appreciate it!!