Which Pullies?

rudeone707 · Apr 27, 2004

Im going to do my balancer this weekend so i figured i might as well swap some pullies since one will be off already and ill have to remove the fan and maybe the radiator for the extra clearance. So which pullies should i go with? I was looking at either FRPP, ASP, or March. Who has the best quality? And where should i get them from? I was looking at thunder racing and they had descriptions that said 26% crank and 30% water pump, what does that mean?

DaveB · Apr 27, 2004

I've had my 3 peice ASP set from Thunderracing for about a year and a half and haven't had any problems at all because of them. People are more than likely just going to tell you what they have. The car seemed to rev up a fair bit faster after I had the pullies installed. And for $100 you can go wrong. Im pretty sure those percentages are how much they slow that accessory down.

SN95StangMan · Apr 28, 2004

ASP Aluminum, powdercoated black. The only problems I've ever had was today when the 605 was closed and I had to take the street to get to school. Traffic was horrible. Took me 30 minutes to get just 3 miles. Car was running hot and volts were down a little. The 100+ temps didnt help cool the car down either. Other than that though, I have had no problems. I do have the occasional drop in voltage when sitting at a long red light at night, but that is fixed the moment I start moving again. No matter what you go with, I will still be a good bang for your buck.

wytstang · Apr 28, 2004

rudeone707 said:
Im going to do my balancer this weekend so i figured i might as well swap some pullies since one will be off already and ill have to remove the fan and maybe the radiator for the extra clearance. So which pullies should i go with? I was looking at either FRPP, ASP, or March. Who has the best quality? And where should i get them from? I was looking at thunder racing and they had descriptions that said 26% crank and 30% water pump, what does that mean?

www.racenet.net has them for just under $100 check them out.

wytstang · Apr 28, 2004

rudeone707 said:
Im going to do my balancer this weekend so i figured i might as well swap some pullies since one will be off already and ill have to remove the fan and maybe the radiator for the extra clearance. So which pullies should i go with? I was looking at either FRPP, ASP, or March. Who has the best quality? And where should i get them from? I was looking at thunder racing and they had descriptions that said 26% crank and 30% water pump, what does that mean?

www.racenet.net has them for just under $100 check them out. asp.

JJ95GTID · Apr 28, 2004

I have the Mac billet steel pullies on the crank and water pump. I put the stock alternator pulley back on cause I did not like the alternator shutting off at idle in traffic. Definately a noticable power gain at the 1/4 mile.

Which Pullies?

rudeone707

New Member

DaveB

SN95StangMan

New Member

wytstang

Mustang Master

wytstang

Mustang Master

JJ95GTID

Active Member

Similar threads

Which Pullies?

rudeone707

New Member

DaveB

SN95StangMan

New Member

wytstang

Mustang Master

wytstang

Mustang Master

JJ95GTID

Active Member

Similar threads

Privacy & Transparency

Privacy & Transparency