So Im trying to install my xpipe which seems simple. IF I CAN GET THE OTHER DAMNED OEM PIPE OFF. Anyway, ODDLY ENOUGH, I got the passenger side nuts off relatively easy with a lot of WD40, And swivel Joint, Extensions, , and 5/8 deep well. The 5/8 seemed a tad big but it worked..... After getting the most difficult passenger side nuts off, I thought I had it made.... I went for the most difficult driver side nut... Got it off...
Finally I am down to my last nut. Its the simplest to get to so I can already see the finish line. I start to turn my ratchet then BAM
So my question would be,
Now that this bolt has been beat, squirted, and boogered with every tool I have.. What's next? I had to give up when the sun went down but I dont even have a plan for tomorrow.
I have tried Pipe wrench, Under sized wrench beat on, Vise grips, Hammer, Prayer, Good karma, Hope, channel locks, any pare of pliers I could find, etc etc.
I am strait out of ideas and the damned thing will not budge... I know as soon as I get half a turn it will come right off but the thing is basically welded!
Please help!
Finally I am down to my last nut. Its the simplest to get to so I can already see the finish line. I start to turn my ratchet then BAM
So my question would be,
Now that this bolt has been beat, squirted, and boogered with every tool I have.. What's next? I had to give up when the sun went down but I dont even have a plan for tomorrow.
I have tried Pipe wrench, Under sized wrench beat on, Vise grips, Hammer, Prayer, Good karma, Hope, channel locks, any pare of pliers I could find, etc etc.
I am strait out of ideas and the damned thing will not budge... I know as soon as I get half a turn it will come right off but the thing is basically welded!
Please help!