Scenario- 91GT. 160K miles. Modified in 1990's(exact history unknown) with B springs(verified) and crappy struts- silver ones in front(KYB GR2?) And yellow ones in the back-- I think Monroe, they're not Billstiens. I'm pretty sure the struts are old and worn out as well. The car has the stock camber plates. There is poly bushings on the sway bar and under the transmission. Everything else appears to be stock.
I'm looking for ride quality first and handling performance secondary. Would like a slightly lowered look though so no stock GT springs.
This goddamn car rides so bad I'm almost mad that I let myself buy it. The front end bottoms out very easily. The car darts all over the road at any slight irregularity in the surface. Tons of NVH into the cabin. Just crap.
I'm trying to figure out an approach to get a decent ride-- keep in mind this is Wisconsin and are roads are terrible inside most of the cities. Slab concrete, pot holes, bumps, cracks, etc.
I'm thinking Bullitt springs and Tokico blues. Should I use poly isolators? Is there any other bushings to replace during a spring/strut swap I may need to address?
Looking for some veteran opinions on this so I can get this car setup so it's actually enjoyable to drive. Thanks!