Search results

  1. modulistic

    2002 Gt Sohc Injector Body Style? Ev1?

    long story, but the gist of it is I was pulling the motor from underneath along with the K frame, and forgot to unhook the fuel line. consequently I started pulling and bent the fuel rail to hell and had to get a professional products fuel rail kit. the kit fit great with the stock injectors...
  2. modulistic

    Another Crank No Start.

    Did a modfox swap and got it started before I got the interior in. Got the interior in and now I'm having crank no start. Can smell gas out the tailpipes after cranking. Have voltage at injector and cops with key on. Should the tach be moving during cranking? Pats proves out. Fuel pump...
  3. modulistic

    Bent The Fuel Rail, Please Suggest Options

    doing a modfox swap, 2002 2v - I forgot to unhook the fuel line at the fuel rail when dropping the engine/kframe out the bottom. consequently, I bent the passenger side fuel rail all to hell and it leaks. Whats a good stockish fuel rail to get? I want to spray it eventually, but I dont need...
  4. modulistic

    Modular Fox Swap. Turns Over But No Fuel Pump.

    I am at the point in my swap where im trying to test run the motor. as the thread title says, It will turn over but im not getting any fuel pump sound or pressure. The entire harness and computer and fuel tank/pump came over with the 2002 4.6. I dont have the cluster plugged in, I dont think...
  5. modulistic

    4.6 Swap Underway. Need Ideas To Solve Rear Axle Problem.

    alright, so this is happening. Please dont bitch at me about why Im doing a SOHC into the fox. Thats just how it is. So, the red hatch used to be a 5.0, but I swapped everything out of it into a 4cyl, its a shell - it now sits on a 4cyl axle. The newedge track width is like 1.5 inches wider...
  6. modulistic

    Popping/clicking When Pressing In Clutch.

    I'm trying to figure out wtf I did wrong with the clutch. I swapped the entire drivetrain from a donor car and when the clutch cable came over it was about a quarter inch too short for the double hook quad. Ordered up a triple hook and had to adjust it way out on the firewall adjuster, using...
  7. modulistic

    Weak Spark At Coil, No Spark At Plug

    @jrichker car sputtered then died while normal driving. Took a spark plug cable and ran it from coil to ground, with a small gap at the ground end. No spark, so I started troubleshooting no spark. Pulled the tfi and tested. One of the ohm measurements was off, so replaced the tfi. Still no...
  8. modulistic

    Pop Quiz Time. Stumbling / Missing At Low Rpm With Moderate Load

    Stumbling at low rpm only after warm. Threw lean codes. Plugs look nice, idle and starts nice. Drives fine until operating temp. Felt like a shudder or pulse as the rpms climbed. Was fine at cruise speed. Mods. 302, e303 cam, long tubes, h pipe, vortech v3, stock tune running fmu. 3.08 5...
  9. modulistic

    Edelbrock Performer Heads Part# 6037

    are these the cheap heads with the flimsy springs? is 950 a good price for middle of nowhere, AK?
  10. modulistic

    Talk Me Out Of Putting A Wet Kit On My V3-si Blown Stock Block

    so my issue up here is getting a tune. Not too easy to come by in Alaska. So I got to thinking - how can I get more fuel in without going through the injectors? Then my mind wandered back to my LS1 F-body days when I ran a 150 wet shot, which was extremely easy to install. it just screwed on...
  11. modulistic

    Vortech Guys,quick Question, Fuel Pressure Reg.

    do i leave the vac line running to the fuel press reg on the rail, or let the fmu do all the work?
  12. modulistic

    Someone Please Hold My Hand Re: Wide Band O2 Sensor And Gauge

    Just got the v3 in the mail, and am needing to get a wide band in there. What brand is good, and I guess drivers side long tube collect area for the bung. What are you looking for while the gauge is running... in the videos I've seen, the number flies all over the place. I guess just that...
  13. modulistic

    Ignition Switch Connector Getting Hot With Blower Fan On High

    Anyone heard of this? While swapping my steering column (89 tilt into 92) I noticed the ignition in the 89 had partially melted, and the previous owner kinda ziptied it together. I used the ign from the 92 column. I just happened to be reaching down there troubleshooting something else, and...
  14. modulistic

    Upr C/c Install Question

    the instructions make mention of a bushing, which I am not finding in the diagram, or in my parts inventory. pictures on the internet dont seem to show a bushing, but I am not sure. it doesnt look like a bushing would do too much good here, since the strut appears to lock into the bearing...
  15. modulistic

    When Purchasing Heads, Does Year Of The Block/car Make A Difference.

    someone has a posting for world jr 302 heads, and its apparent that he was carbed, as he is selling the intake and carb as well. Are heads year/carbe/forced injection specific or could I make these work on an 87 block?
  16. modulistic

    4 Cyl Swap, Front Strut Question.

    In the middle of swapping the front end over. I grabbed the entire strut assembly including the three bolts and top plate, thinking the perches were the same. Was very startled that it doesn't fit, as I thought the bodies were the same between 4 cyl and 5.0. So question is, will the 5.0 strut...
  17. modulistic

    Is There A Waybto Find Out What Diablo Tune Is In My 5.0?

    I'm doing a 4cyl to 5.0 swap, and am in the process of gutting the 5.0. Got the main body harness out, and was checking the pcm and it has a little slip of paper that says diablo. Is there any way to look up what tune is on the computer? Sorry for the typo in the title, am on a tablet.
  18. modulistic

    Question On Purchasing Short Blocks

    What years of 302 or 351 will be able to bolt in and work with efi cams and ecu? Want to get a block to build up over the winter, but don't want any weird surprises. For instance, there are two 69 blocks near me for cheap, but I don't know if they would work.
  19. modulistic

    16x8 With +15 Offset?

    will this work/look ok on a 95? how "sunken in" will that look? what tire size will fill the wheel well on stock suspension with these rims?
  20. modulistic

    fr500 rims on a stock 95

    will they fit? does it look ok?
Top Bottom
Back
Forums
Menu