I have a 03 cobra with a mgw shifter and I can’t for the life of me find a shift knob. Does anyone know where I can find out the thread size and where to get a knob? Thank you
Hi,
I have been out of this world for so long with kids and a career.. and im looking to get back into it. I would like a honest opion on what a clean 2001 complete IRS with a bunch of upgrades is worth. I completely changed directions with my 79 coupe that i have and really think i should...
I have a 91 mustang gt hatchback. I hate to sellit but I just don’t drive it or need it at this point in life. It’s a factory all black interior car with no REAL wear on it. It looks 20 to 15 years younger than it is inside! I’m not sure of the mileage on the motor but it has been swapped due to...
Hello,
I recently bought an 01 cobra from a buddy for pretty cheap. Its been sitting for approx 2 years, so I replaced all the fluids and finally started her up. After running for a little bit it began overheating. I reburped and flushed the coolant and still had the same issue, with no change...
1994 Mustang Cobra
Everything working except for the handbrake. Exterior in good shape for the age but not perfect. Interior is almost like new. Very few modifications. Muffler delete/x pipe. Pioneer head unit and sub in trunk. Cobra R wheels. AC blows ice cold. 96xxx on the dash. Asking $9500...
Trying to get a realistic value on these black quarter panels and the black door panels .I have checked eBay but there's no sold items for comparison and everyone is asking the world for there hot Garbage .
So it has been a long time coming and I think it is time to part with this car but I have no idea what to ask for it. Would $7000 be unreasonable?
1979 Ford Mustang Cobra Tangerine Chamois interior
1998 Ford Explorer engine with TFS Stage 1 cam Edelbrock RPM Performer intake Holley 770 Street...
Hey all -
Tried to search many forums and cannot find a solution. I have a 96 cobra that has low compression on all cylinders. However - a leakdown test was performed, and each cylinder seals like it should when the crank is turned manually. Which has me guessing it’s a timing issue? I’ve seen...
I built this car 20 years ago with intentions to auto cross but I paused it to start a family.
302 bored 0.040 over Kieth Black pistons,
Ported Twisted wedge heads and Cobra intake, 24lb injectors, ECM Chip
E303 Cam, electric water pump, dual fans (needs to be finished) MSD 6AL ignition...