Before I start, thanks to SVT32VDOHC for hooking me up with a set of 94-95 5-lug spindles! :SNSign:
Here is the deal. I'm slowly getting parts together for a 5-lugger, and I need some input. I'm buying most of the needed parts new, but of course the spindles are used and rusty.
What suggestions do you have on freshening these up? I was thinking about getting them sandblasted at a machine shop then replacing the hubs (I was thinking that leaving the old ones on would protect the axle from the 'blast), and spraying them with some sort of a rust inhibiting paint.
Also, only one has an ABS hub. I see that strangely, ABS hubs are cheaper to replace. I'm hoping to just throw ABS hubs on to save money. Is this possible?
Here is the deal. I'm slowly getting parts together for a 5-lugger, and I need some input. I'm buying most of the needed parts new, but of course the spindles are used and rusty.
What suggestions do you have on freshening these up? I was thinking about getting them sandblasted at a machine shop then replacing the hubs (I was thinking that leaving the old ones on would protect the axle from the 'blast), and spraying them with some sort of a rust inhibiting paint.
Also, only one has an ABS hub. I see that strangely, ABS hubs are cheaper to replace. I'm hoping to just throw ABS hubs on to save money. Is this possible?