that should be ok it just has a higher voltage handling. I would check the spec sheets and make sure it meets or exceeds the 1n4001I only have 1n4007 diodes
that should be ok it just has a higher voltage handling. I would check the spec sheets and make sure it meets or exceeds the 1n4001I only have 1n4007 diodes
that should be ok it just has a higher voltage handling. I would check the spec sheets and make sure it meets or exceeds the 1n4001
Even better, higher PIV.I only have 1n4007 diodes
AC cycle switch on pin 10 is a 12v+ input signal. I used the nitrous input for this. The wot relay needs a ground trigger, an unused inj output will do just fine. You will want to find the relay and swap pin 87a to 87. This way the MS3 can turn the compressor on instead of off, this is how i did mine.
I like to take the grounds to a common wire that travels back to the battery for the lowest ground offset value.
Ah ok, have you posted this diagram already? I can take a look at it. If needed I can help you do this with loop function so it's a moot point. Just continue onFound an issue here this relay is part of the 94-95 CCRM and is located on a PCB. How can I make this work?