I have a question on air/fuel ratio. Not sure if anybody can help or not. Ultimately I must dyno my car to have the air/fuel ratio set the best way, but until I can get to a dyno I would like to know if there is a good way to set it w/the mods that are done to my car. I have a 00 Mustang GT w/43,000 miles on it. The bolt-on mods are as follows:
Densecharger CAI, BBK 75mm TB, C&L intake plenum, Steeda Pulleys, Steeda Timing adjuster(15*), MAC off road H pipe, MAC exhaust, and Diablosport Predator performance tune.
Should I leave my air/fuel ratio untouched until I can hit the dyno, or is there a better setting I could select w/the Diablosport until I do get to the dyno?
Any help is greatly appreciated.
Todd
Densecharger CAI, BBK 75mm TB, C&L intake plenum, Steeda Pulleys, Steeda Timing adjuster(15*), MAC off road H pipe, MAC exhaust, and Diablosport Predator performance tune.
Should I leave my air/fuel ratio untouched until I can hit the dyno, or is there a better setting I could select w/the Diablosport until I do get to the dyno?
Any help is greatly appreciated.
Todd