• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

Bad Master Cylinder?

  • Thread starter Thread starter gnx547
  • Start date Start date Aug 6, 2007

gnx547

Member
Sep 26, 2006
283
1
19
Aug 6, 2007
#1
  • Aug 6, 2007
  • #1
Lately I notice my brake pedal is soft and not firm. I recently replaced my wheel cylinders and I bled the right rear and the left rear. After bleeding it 5 times on both sides the brake pedal isn't to firm at all. When I test drove it and when stopping the pedal goes to the floor, its just not firm at all...So then I decided to bleed all 4 wheels again starting with the wheel far away from the master cylinder, which is the right rear..So after bleeding all 4 wheels, its still not firm at all..I check for leaks around the master cylinder, front & rear brake lines and hoses and no leaks at all. My front pads are good and my rear shoes are good with new wheel cylinders..Could I have a bad master cylinder causing a soft brake pedal and not firming up after bleeding?
 

Mustang5L5

That is…until I whipped out my Bissell
Mod Dude
Feb 18, 2001
43,374
18,120
224
Massachusetts
Aug 6, 2007
#2
  • Aug 6, 2007
  • #2
With the car off, pump the pedal. After 3-4 pumps, does the pedal get rock hard??

If you hold it pressed...does it eventually bleed down??


How about when driving. If you do rapid pumps when stopping, does the pedal firm up??
 

gnx547

Member
Sep 26, 2006
283
1
19
Aug 6, 2007
#3
  • Aug 6, 2007
  • #3
Mustang5L5 said:
With the car off, pump the pedal. After 3-4 pumps, does the pedal get rock hard??

If you hold it pressed...does it eventually bleed down??


How about when driving. If you do rapid pumps when stopping, does the pedal firm up??
Click to expand...


Yes with the car off 3 to 4 pumps the pedal does get rock hard...It does hold but when I start the car and start driving the pedal does sink down and its not firm at all...I bled all 4 wheels several times with no improvement and I have no leaks at all..I am thinking the master cylinder is bad causing my pedal to feel soft all the time and not being firm.
 

Mustang5L5

That is…until I whipped out my Bissell
Mod Dude
Feb 18, 2001
43,374
18,120
224
Massachusetts
Aug 6, 2007
#4
  • Aug 6, 2007
  • #4
i agree. Firm pedal would suggest no air.
 

gnx547

Member
Sep 26, 2006
283
1
19
Aug 7, 2007
#5
  • Aug 7, 2007
  • #5
I was just thinking about this, when I put the shoes back on I put the drums on and I bled the wheel cylinders. After bleeding it there was a slight drag when I turn the drum. But I DIDN"T adjust the star wheel..Was I supposed to adjust the star wheel after I installed the shoes? After bleeding it I couldn't get the drum off, which told me the shoes expanded and adjusted automatically and I felt the slight drag when I spinned it, So I was thinking that the shoes are already adjusted because of this...Could it be that for me not adjusting the star wheel cause my brake pedal to drop down slightly & feel soft and not firm at all after bleeding the wheel cylinders? Should I go back and adjust the star wheel? Any thoughts?
 

88mouse

New Member
Apr 18, 2007
630
0
0
Mooresville nc
Aug 7, 2007
#6
  • Aug 7, 2007
  • #6
If the pedal is low to the floor yeah the brakes need to be ajusted. But a soft pedal means there is air some where.
 
You must log in or register to reply here.

Similar threads

Brakes Foxbody Brakes still soft
  • 86posmustang
  • Nov 5, 2025
  • Fox 5.0 Mustang Tech
Replies
10
Views
771
Fox 5.0 Mustang Tech Dec 3, 2025
nicholase
2000 GT-Front Brakes Not Releasing
  • stormsedge
  • Aug 7, 2026
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
5
Views
254
1996 - 2004 SN95 Mustang -General/Talk- Aug 7, 2026
Bronco2fan
B
W
Front ATS brakes with Taurus rear brakes. Full parts needed?
  • Wagonized
  • Sep 24, 2026
  • Fox 5.0 Mustang Tech
Replies
3
Views
298
Fox 5.0 Mustang Tech Sep 25, 2026
General karthief
Fox Brake pedal too stiff
  • keel
  • Sep 21, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 2
Replies
33
Views
979
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Nov 11, 2026
keel
1970 brake issue. Bad booster or?
  • All Stock93
  • May 13, 2025
  • 1965 - 1973 Classic Mustangs -General/Talk-
Replies
10
Views
865
1965 - 1973 Classic Mustangs -General/Talk- Sep 13, 2025
All Stock93
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?