Lately I notice my brake pedal is soft and not firm. I recently replaced my wheel cylinders and I bled the right rear and the left rear. After bleeding it 5 times on both sides the brake pedal isn't to firm at all. When I test drove it and when stopping the pedal goes to the floor, its just not firm at all...So then I decided to bleed all 4 wheels again starting with the wheel far away from the master cylinder, which is the right rear..So after bleeding all 4 wheels, its still not firm at all..I check for leaks around the master cylinder, front & rear brake lines and hoses and no leaks at all. My front pads are good and my rear shoes are good with new wheel cylinders..Could I have a bad master cylinder causing a soft brake pedal and not firming up after bleeding?