Build will be done!!!

[scupking]

Next week my build should be done, I'm just waiting on my LT headers and VRS catted X pipe. Once again to go over what will be done.

Hitech Stage II cams
Mac LT headers
VRS shorty Catted X
FRPP 4.10 Gears
MM full length sub frames
Tranny cooler
B&M hammer shifter
93 Oct Dyno tune

Can't wait for her to be done. I have my fingers crossed that I will be around 300 rwhp.

 

[jlds91389]

congrats and good luck on your numbers.

 

[TGJ]

Next week my build should be done, I'm just waiting on my LT headers and VRS catted X pipe. Once again to go over what will be done.

Hitech Stage II cams
Mac LT headers
VRS shorty Catted X
FRPP 4.10 Gears
MM full length sub frames
Tranny cooler
B&M hammer shifter
93 Oct Dyno tune

Can't wait for her to be done. I have my fingers crossed that I will be around 300 rwhp.

Who installed the cams? Ensure that they check PTV clearances before they start the car. There is about a half dozen Hi-Tech Stg 2 cammed cars that have had PTV contact...

 

[Winters98GT]

Who installed the cams? Ensure that they check PTV clearances before they start the car. There is about a half dozen Hi-Tech Stg 2 cammed cars that have had PTV contact...

+1, I've read a few threads on other boards where there have been issues.

I wouldn't shoot for a dyno benchmark, dyno's can vary slightly. Your car is going to completely different with those mods.

 

[BlownStangGT]

Sounds good. Should be a pretty stoudt car when done. But I have learned, its not always about what numbers it makes.....its what numbers it runs at the track

 

[TropicMustang]

Can i have you 3.73's? lol