Cam swap in car.

Venom351R · May 18, 2008

Blackened302 said:
got it done--condenser wasn't a problem at all. i appreciate the help, guys.

What did you do as far as the condenser so it was not a problem? My cam is being swapped soon I want there to be as few issues as possible.

Blackened302 · May 18, 2008

took out the NX282HR and put in a TFS stage 1. also put in a new timing chain set.

unbolt the two condenser brackets up top (one on each side), pull it out just a bit so you can move it around, then you can bungee it up, tie it, or just hold it out of the way.

Venom351R · May 18, 2008

Blackened302 said:
took out the NX282HR and put in a TFS stage 1. also put in a new timing chain set.

unbolt the two condenser brackets up top (one on each side), pull it out just a bit so you can move it around, then you can bungee it up, tie it, or just hold it out of the way.

awesome sounds good

+1 on doing the timing chain, might as well since you are in there. How do you like the TFS Stage 1 so far?

Blackened302 · May 18, 2008

well, i'm not sure.. i haven't driven it yet. it's been a busy last few days, including getting all this work done. probably won't mess w/ it again until next weekend. looking forward to the stock-like driveability!

Cam swap in car.

Venom351R

Blackened302

Active Member

Venom351R

Blackened302

Active Member

Similar threads

Cam swap in car.

Venom351R

Blackened302

Active Member

Venom351R

Blackened302

Active Member

Similar threads

Privacy & Transparency

Privacy & Transparency