i took of my smog pump line that goes to the h pipes. one line i didnt plug up. would this have anything to do with no heat? sorry if this is a dumb question. im out of town right now and was thinking about it.
changed heater core but still no heat
- Thread starter warriorpluto
- Start date
hotcobra03
Active Member
Dont think so but the heat knob is attached to the cable remember that is the blend door which allows more cold air to enter try thier
BK_CAULEY
it's built for speed not longevity, woman
yep. it has this small plastic piece thats on the back of th eknob control cluster and mine broke off. make sure you dont have one of those flow restrictor things also.
oh ok. thanks im going to check that when i get back home and take off the center console. thats might be the problem cause when i turn the temp knob to heat the knob turns back the other way a little bit. where can i get replacement plastic and cable? and can i get it from a four banger cause there are plenty in the junkyard.
hotcobra03
Active Member
BK_CAULEY
it's built for speed not longevity, woman
yep its all the same. if you are saying its kinda binding the cable might be sticking causing it to turn back some and not open the blend door.
yep thats exactly what its doing. im going to have to hurry and replace that before it gets too cold to do anything.
i have one more question. on some year the temp control panel was switched to the other side. will it still fit my car cause i have an 87 and i think in 89 they changed the temp panel around.
hotcobra03
Active Member
Similar threads
Progress Thread
mnky99 2001 V6 evap core, ac compressor, heater core replacement